KB 125 (ABAP) - Change Splunk connection settings

Description

The following steps should be used to change Splunk connection settings:

• Log into the system where the PowerConnect application was installed, and execute the /n/bnwvs/main transaction. Then go to Administrator → Splunk Setup → Upload Scheme:
  
  

  Open

  

• Select necessary endpoint on the right side of the screen and click ‘Edit’ button on the toolbar (double-click will do the same):

  Open

  

• After the configuration change, click ‘Check’ button to verify the settings. If if the connection is valid, following dialog boxes will be shown:

• Confirm the dialog.

• Save changes using ‘Save’ button and exit.
  
  

• Restart Uploader job using ‘Toggle uploader’ button to apply changes.